 |
 |
 |
||||||
 |
|
 |
||||||
|
Auto Cross, Drag Racing, Car Show, Awards & Prizes - Register Now! |
||||||||
|
|||||||
General Technical Chat This section is for technical discussions relating to general maintenance, electrical issues, engine trouble, and recalls.
|
 |
 |
|
|
|
Thread Tools | Display Modes |
01-19-2013, 09:46 PM
|
#11 | ||||
|
Focus Jr. Enthusiast
 
|
Wow that sucks, and yeah I can't beleave how much valves cost its stupid!
__________________
Claim not, dynos prove all! |
||||
|
|
|
02-01-2013, 11:21 PM
|
#12 | ||||
|
Focus Jr. Enthusiast
|
so I measured my valves after reassembling the head and only a few were a issue so I took a little bit off the valve not much and im all set!
__________________
Claim not, dynos prove all! |
||||
|
|
|
|
02-02-2013, 04:58 AM
|
#13 | ||||
|
Focus Fanatic
 |
I used same stunt on DOHC Honda bikes and worked fine, you just gotta watch the valvetip to retainer flat clearance. Thinking the tips there were nitrided too, but they sank so fast into seats that the extra wear from soft tip once nitride removed seemed to offset each other.
|
||||
|
|
|
|
| Bookmarks & Social Networks |
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
All times are GMT -5. The time now is 07:48 PM.
 |
|
 |
||
 |
|
 |