NEW PRODUCT: Steeda Focus ST Rear Engine Mount - 2013 ST

[SteedaJohn]

Help control engine deflection and get more power to the ground with Steeda's Lower Engine Mount for your Focus ST

Our upgraded mount is designed from 6061 billet aluminum with a choice of different bushings packages to fine tune the level of control and NVH.

Read more here: http://www.steedafocus.com/parts/foc...ine-mount.html

[Slo86GT]

Will this product fit the n/a models of the Focus as well? Whoever designed the mount system on these cars was clueless. I can get a healthy thump of something rocking around underhood shifting hard into fourth gear. :-/

[Albarry]

I just ordered this!! Hope it helps

[suss6052]

Originally Posted by Slo86GT

Will this product fit the n/a models of the Focus as well? Whoever designed the mount system on these cars was clueless. I can get a healthy thump of something rocking around underhood shifting hard into fourth gear. :-/

Since the ST uses the same mount as the standard MK3 the verdict is yes so far until proven otherwise.

[Albarry]

I will know for a fact in about a week.

[Albarry]

Mount is sweet!! If you drive your car hard get this!!

[rkite]

Which bushing did you get? How much extra vibration and noise?

[ChalupaJones]

Originally Posted by rkite

Which bushing did you get? How much extra vibration and noise?

Did a little hunting, there seems to be either a 70 duro or an 88 duro. Says that the 70 duro will still give you a smooth ride. I like the look of this mount. Seems to be a lot more sturdy than the stock one.